A. 1
B. 10
C. 1562
D. 64000
E. 128000
F. None of the above
If the bandwidth of an OSPF interface is 64, what would be the calculated cost of the link?（）A、1B、10C、1562D、64000E、128000F、None of the above
点击查看答案
The following output was taken from Router R3. A scan of R3's configuration shows that no bandwidth commands have been configured in this router. Which of the following answers lists configuration settings could be a part of a configuration tha t results in the following output?（） R3#show ip ospf interface brief Interface PID Area IP Address/Mask Cost State Nbrs F/C Se0/0/0.2 3 34 10.10.23.3/29 647 P2P 1/1 Se0/0/0.1 3 34 10.10.13.3/29 1000 P2P 1/1 Fa0/0 3 34 10.10.34.3/24 20 BDR 1/1A、An a uto - cost reference - bandwidth 1000 command in router ospf modeB、An auto - cost reference - bandwidth 2000 command in router ospf modeC、An ip ospf cost 1000 interface S0/0/0.1 command in router ospf modeD、An auto - cost reference - bandwidth 64700 command i n router ospf mode
What is the default metric used on IS -IS routers for each interface?（）A、The cost is set to 10 for all interfaces.B、The cost is set to 10 for LAN interfaces and 20 for WAN interfaces.C、The cost is based on the speed of the interface.D、The cost is based o n a composite of bandwidth and delay of the interface.
How is the cost of a virtual link in OSFP calculated？（）A、Takes the metric of the outgoing interface.B、Uses the metric that is assigned during configuration.C、Uses the path metric to reach the virtual neighbor.D、Uses a default of zero unless otherwise specified.
In JUNOS software, what is the default interface metric for IS-IS?（）A、1B、10C、100D、10^8/link bandwidth
Which parameter or parameters are used to calculate OSPF cost in cisco routers？（）A、Bandwidth，Delay，and MTUBB、andwidthC、Bandwidth and MTUD、Bandwidth，MTU，Reliability，Delay，and Load
An OSPF interface has been configured with the bandwidth 64 command. What will be the calculated OSPF cost of this link?（）A、1B、10C、1562D、64000E、128000
