st0
fxp1
fab0
reth0
A customer has two single cluster IBM TS7700 Virtualization Engines at the same site. The customer wants to move one to a remote site and set up a grid configuration with the two clusters. The customer has fibre between the two sites. What is the most important factor to consider when planning the new configuration?()A、operator trainingB、cache size of the two clustersC、fibre bandwidth capability between the sitesD、number of stacked tape drives attached to each cluster
点击查看答案
An architect is configuring a PowerHA cluster in the following way:The cluster will consist of two nodes. Each node will have two boot interfaces configured as a single PowerHA network. The cluster is to have asingle resource group with a single service address.Heartbeating over aliased is not to be used. What is the minimum number of subnets required to implement this cluster?()A、1B、2C、3D、4
A two-node cluster is configured for mutual takeover with two service IP labels. The cluster is Being tested for fallover behavior. Both nodes in the cluster have two network interfaces (ent0’ and ’ent1’) configured with IPAT via IP Replacement. When the network cable is removed from the interface card with the service address (’ent0’), the service address is moved to ’ent1’, and ’ent0’ is reconfigured on its boot address. When the network cable is replaced on ’ent0,the service address does not switch back to ’ent0’. What statement most accurately describes this situation?() A、 EtherChannel is needed to automatically switch the service IP address back to ’ent0’.B、 This is the default behavior for a network interface failure with this configuration.C、 Gratuitous ARP support needs to be enabled for the IP Network Interface Module in SMIT.D、 The Inactive Network Takeover option should be set to "true" to forece the service address back to ’ent0’.
[edit groups] user@host# show node0 { system { host-name NODE0; } interfaces { fxp0 { unit 0 { family inet { address 1.1.1.1/24; } } } } } node1 { system { host-name NODE1; } interfaces { fxp0 { unit 0 { family inet { address 1.1.1.2/24; } } } } } In the exhibit, what is the function of the configuration statements?()A、This section is where you define all chassis clustering configuration.B、This configuration is required for members of a chassis cluster to talk to each other.C、You can apply this configuration in the chassis cluster to make configuration easier.D、This section is where unique node configuration is applied.
In a chassis cluster with two SRX 5800 devices, the interface ge-13/0/0 belongs to which device?()A、This interface is a system-created interface.B、This interface belongs to node 0 of the cluster.C、This interface belongs to node 1 of the cluster.D、This interface will not exist because SRX 5800 devices have only 12 slots.
Which two statements are true regarding high-availability chassis clustering?()A、A chassis cluster consists of two devices.B、A chassis cluster consists of two or more devices.C、Devices participating in a chassis cluster can be different models.D、Devices participating in a chassis cluster must be the same models
Which command would you use to enable chassis cluster on an SRX device, setting the cluster ID to 1 and node to 0?()A、user@host# set chassis cluster cluster-id 1 node 0 rebootB、user@host> set chassis cluster id 1 node 0 rebootC、user@host> set chassis cluster cluster-id 1 node 0 rebootD、user@host# set chassis cluster id 1 node 0 reboot