1.25Gbps
1.65Gbps
2.55Gbps
5.00Gbps
Which three statements about VTP features are true?()A、When properly configured,VTP minimizes VLAN misconfigurations and configuration inconsistenciesB、Each broadcast domain on a switch can have its own unique VTP domainC、VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured.D、When properly configured,VTP maintains VLAN configuration consistency and accelerates trunk link negotiation.E、VTP pruning is used to increase available bandwidth in trunk linksF、Client,server,and transparent are valid VTP modesG、To configure a switch to be part of two VTP domains,each domain must have its own passwords
点击查看答案
Which statement is true about full-duplex Ethernet in comparison to half-duplex Ethernet?()A、Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.B、Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.C、Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.D、Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?()A、More collision domains will be created.B、IP address utilization will be more efficient.C、More bandwidth will be required than was needed previously.D、An additional broadcast domain will be created.
When creating a service profiIe using the Expert Wizard in a single vlan vnic configuration which four optionsare available?()A、Fabric IDB、Native VlanC、Vlan TrunkingD、Trunk encapsulationE、Mac Address assignment
Which two statements about SCSI are true? ()A、 The bus is limited to 32 devicesB、 It is a full duplex serial standardC、 It is a half-duplex serial standardD、 It allows up to 320 MB/s of shared channel bandwidth
When using Cisco Network Assistant to configure a WS-CE500-24LC switch, which three are available choices in the port settings window?()A、Duplex mode selectionsB、Auto MDIX selectionsC、Status SelectionsD、Group mode selectionsE、Port security selections
A customer wants to install an IBM BladeCenter infrastructure but is concerned about the cost of the full fabric internal fibre switches. Consequently, the customer is considering an N_Port ID Virtualization (NPIV) capable switch. Which of the following should be mentioned to the customer regarding the NPIV switch?()A、Youcan not use an NPIV switch in the same IBM BladeCenter chassis as a Cisco Intelligent Ethernet SwitchB、Using blade servers with the NPIV switch will require morefibre ports on the external fibre switchC、Storage devices likeFibre Channel Tape and Disk cannot be attached to the NPIV Switch but must connect to a core fabric switch.D、The NPIV switch will count against the number of domains in a fabric