1 - 7
1 - 16
0 - 7
0 - 15
Which of the following must occur when installing SCSI devices into the server?()A、 Terminate the back end of the chain.B、 Set the jumper to device ID 0.C、 Terminate both ends of the chain.D、 Set the jumper to cable select.
点击查看答案
Which of the following internal storage technologies has the HIGHEST single drive storage capacity? ()A、 SASB、 SATAC、 FlashD、 SCSI
Which of the following MOST likely causes problems with SCSI communication?()A、Low communication latencyB、Maximum drive capacity is exceededC、Improper terminationD、Too many SCSI devices on one system
A technician needs to install the first SCSI controller in an application server. The SCSI card is factory-configured with a SCSI ID of 1. Which SCSI ID should the technician configure the card before installation?()A、 0B、 1C、 4D、 7
Which of the following technologies was created to reduce cost, increase cable length, and uses 3.3v across the line?()A、Wide-Ultra2 SCSI-3B、High-Voltage DifferentialC、Low-Voltage DifferentialD、Fibre Channel
Which of the following will attach to an EIDE connector?()A、SATA-2B、SAT AC、ATA-2D、SCSI
In which of the following configurations should a SAS hard drive jumper be placed for single drive operation?()A、 The jumpers should be placed in the single/master position.B、 There are no configuration jumpers needed on a SAS hard drive.C、 The jumpers should be placed to give the drive a SCSI ID of 1.D、 The jumpers should be placed in the slave position.