CDP is running between two TestKing devices. What information is supplied by CDP?（）
Which two characteristics are true of a firewall running in routed mode based on the following information?()A. FWSM routes traffic between the VLANs.B. FWSM switches traffic between the VLANs.C. Routed mode is often called bump-in-the-wire mode.D. Routed mode firewall deployments are used most often in current designs.
点击查看答案
What are two reasons a network administrator would use CDP?()A. to verify the type of cable interconnecting two devicesB. to determine the status of network services on a remote deviceC. to obtain VLAN information from directly connected switchesD. to verify Layer 2 connectivity between two devices when Layer 3 failsE. to obtain the IP address of a connected device in order to telnet to the deviceF. to determine the status of the routing protocols between directly connected routers
Refer to the exhibit. The two exhibit devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? （）A.The Manchester serial address is 10.1.1.1B.The Manchester serial address is 10.1.1.2C.这个Manchester路由器串口地址为：10.1.12D.The London router is a Cisco 2610.E.The Manchester router is a Cisco 2610.F.The CDP information was received on port Serial0/0 of the Manchester router.G.The CDP information was sent by port Serial0/0 of the London Router.
In which two locations in an enterprise network can an IPS sensor be placed?（）A、bridging VLANs on two switchesB、bridging two VLANs on one switchC、between two Layer 2 devices withtrunkingD、between two Layer 2 devices withouttrunkingE、between a Layer 2 device and a Layer 3 device withtrunking
A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command. In which OSI layer is the problem most likely occurring?（）A、PhysicalB、Data linkC、Network layerD、Transport layerE、Application layer
What command verifies connectivity between two hosts by sending and receiving ICMP echo messages?（）A、pingB、tracertC、netstatD、show cdp neighbors detailE、show ip routeF、traceroute
Two Cisco routers are connected to each other and are enabled CDP. Serial line is up，protocol is also up but cdp neighbor not working. What layer of the OSI model does the problem most likely exist？
