Router 1 is configured for BGP as dual-homed on the Cisco network. Which three BGP attributes are carried in every BGP update on this router （both IBGP and EBGP）？（）
下面是路由器Router1的配置命令列表，在空白处填写合适的命令/参数，实现Router1的正确配置。Router1＞enRouter1conf termRouter1(config)iriterface e0Router1(config-if)ip address 192.1.0.129 255.255.255.192Router1 (config-if)interface s0Router1(config-if)ip address 192.200.10.5 255.255.255.252Router1(config-if)endRouter1(config)Eouter (5)Router1(config-router)network (6) area 0Router1(config-router)network (7) area 1Router1(config-router)exitRouter1copy run start
点击查看答案
Refer to the exhibit. Routers R1 and R2 have established a neighbor relationship and are exchanging routing information. The network design requires that R1 r eceive routing updates from R2, but not advertise any routes to R2. Which configuration command sequence will successfully accomplish this task? （）A. R1(config)# router eigrp 1 R1(config - router)# passive - interface serial 0B. R1(config)# access - list 2 0 deny any R1(config)# router eigrp 1 R1(config - router)# distribute - list 20 out serial 0C. R2(config)# access - list 20 permit any R2(config)# router eigrp 1 R2(config - router)# distribute - list 20 in serial 0D. R1(config)# access - list 20 permit any R 1(config)# router eigrp 1 R1(config - router)# distribute - list 20 in serial 0E. R2(config)# access - list 20 deny any R2(config)# router eigrp 1 R2(config - router)# distribute - list 20 out serial 0F. R2(config)# router eigrp 1 R2(config - router)# passive - interface serial 0
Refer to the exhibits. Router B should advertise the network co nnected to the E0/0/0 interface to router A and block all other network advertisements. The IP routing table on router A indicates that it is not receiving this prefix from router B. What is the probable cause of the problem?（）A. An access list on router B is causing the 192.168.3.16/28 network to be deniedB. An access list on router B is causing the 192.168.3.32/28 network to be deniedC. The distribute list on router B is referencing a numbered access list that does not exist on router BD. The d istribute list on router B is referencing the wrong interface
Refer to the exhibit. During the process of configuring a virtual link to connect area 2 with the backbone area, the network administrator received this console message on R3:*Mar 1 00:2 5:01.084: %OSPF -4- ERRRCV: Received invalid packet: mismatch area ID, from backbone area must be virtual link but not found from 20.20.20.1, Serial 0 .How should the virtual link be configured on the OSPF routers to establish full connectivity between the areas?（）A.R1(config - router)# area 0 virtual - link 1.1.1.1R3(config - router)# area 2 virtual - link 3.3.3.3B.R1(config - router)# area 1 virtual - link 2.2.2.2 R3(config - router)# area 1 virtual - link 2.2.2.2C.R1(config - router)# area 1 virtual - link 20.20 .20.2 R3(config - router)# area 1 virtual - link 30.30.30.2D.R1(config - router)# area 1 virtual - link 30.30.30.3 R3(config - router)# area 1 virtual - link 20.20.20.1E.R1(config - router)# area 1 virtual - link 3.3.3.3 R3(config - router)# area 1 virtual - link 1.1 .1.1
What is themostlikelyreasonforthedispartlybetweentheactualnetworknumbersatthebranchesandtheroutesintheroutingtableonGateway－Router?()A.Branch-Router2isconfiguredtosendbothRIPv1andRIPv2updates.B.Gateway-RouterisconfiguredtoonlyreceiveRIPv2updates.C.Gateway-routerisconfiguredtoreceiveonlyRIPv1updates.D.Branch-Router1isconfiguredtoonlysendRIPv1updates.
Refer to the exhibit. What will Router1 do when it receives the data frame shown?()A.Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965.B.Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1.C.Router1 will strip off the destination MAC address and replace it with the MAC address 0000.0c07.4320.D. Router1 will strip off the destination IP address and replace it with the IP address of 192.168.40.1.E.Router1 will forward the data packet out interface FastEthernet0/1.F.Router1 will forward the data packet out interface FastEthernet0/2.
WhatisthemostlikelyreasonforthedispartlybetweentheactualnetworknumbersatthebranchesandtheroutesintheroutingtableonGateway－Router?()A.Branch-Router2isconfiguredtosendbothRIPv1andRIPv2updates.B.Gateway-RouterisconfiguredtoonlyreceiveRIPv2updates.C.Gateway-routerisconfiguredtoreceiveonlyRIPv1updates.D.Branch-Router1isconfiguredtoonlysendRIPv1updates.
